• Čo získam?
  • Reklamný článok zadarmo s možnosťou troch odkazov!
Pridaj článok zadarmo

Ore milling equipment maintenance experience sharing

25/05/18

Ore milling equipment is commonly used in the sand production line and crushing production line. It is known for its good grain shape. It is very important for you to have a long-term stable service for ore counter-breaking equipment. We have brought the ore milling equipment maintenance full secret recipe to share with you. After the new machine is put into operation, a full inspection of the impact must be performed when each shift is completed.

Replacement of wearing parts: When the Ore milling equipment breaks the device and replaces the wearing parts, first open the rear shelves. When using, first remove the connecting bolts of the rear upper frame and the middle box body, then use a spanner to twist the hex head of the flip device, and then slowly open the upper frame. At the same time, the rear frame can be suspended using a hanging device above the rack. Repeat the above process, that is, close the shelves. hammer: impact hammer wear to a certain extent should be adjusted or replaced in time to avoid damage to fasteners and other components. Lining board: After opening the upper cover, remove the cotter pin, slotted nut, and bolt used to fix the impact lining board, and replace the worn back striker lining board. If installing a new impact liner, reverse the above steps immediately.

After the weekly operation, conduct a comprehensive inspection on the counter-hit motor and lubrication. The contents of the inspection include tightening of the fixed parts, belt drive, bearing seals, counter linings, and wear of the lining board for full-position inspection, and a regular maintenance and replacement system in conjunction with the inspection period. Adjustment of clearance between rotor and impact liner: When the rotor of the ore impact and breaking equipment is in operation, the gap between the rotor and the impact liner cannot be adjusted. If the material is stuck between the impact board and the board shell, it is recommended to lift the impact slightly between the adjustment gaps, so that the block feed will become loose and the counterframe will be easily adjusted. If the striker is not sufficient, tap it on a loose lever (protected with a piece of wood). The gap between the rotor and the counter lining is done by the adjustment device of the machine. First loosen the bolt sleeve and then rotate the long nut. The rod will move upwards and it will be tightened tightly.

Bearings: Excessive temperatures may be due to excessive or insufficient grease, dirty grease, and bearing damage. Replacement bearing ore milling equipment will play a key role in the sand production line. Doing every detail is the principle that has always been upheld since the founding of us. We also hope that users will fully repair and maintain the equipment during the operation of the ore milling equipment, killing the problem in the bud to ensure that the ore milling equipment Long-term normal and stable operation.

Viac článkov tohto autora. >

Fatal error: Uncaught Exception: 12: REST API is deprecated for versions v2.1 and higher (12) thrown in /www/doc/www.napis.sk/www/wp-content/plugins/seo-facebook-comments/facebook/base_facebook.php on line 1273