If you want a high operation of the ball mill and good grinding effect, you must be in strict compliance with the operating and maintenance procedures. You should check if the connection bolts are tightened before starting the ball mill; and the if the key of gears and couplings is tightened. As a Seiko production, compact structure, stable quality, to meet the needs of different scale manufacturers, welcomed by the majority of users with the commendation and the ball mill processing manufacturer, we are committed to provide high-quality products such as grinding mills.
The following I will describe the operation process and maintenance tips: Check if the fuel tank and the reducer has adequate oil, if the whole lubrication device and instrument has problems as a whole, if the pipe is open.Check if there is debris impending the running around ball mill and classifier, and then transfer cranes mill a week, loose the spherical charge and ores in tube, and check the meshing of gear ring and pinion, if there is abnormal noise. The start sequence is the first start of a ball grinder lubricant pump, allowed to start when the hydraulic pressure reaches 1.5 to 2.0 kg / cm per hour, a ball, and then start the grading machine. After everything is operating normally, you can start painting mine.
During operation, we should always pay attention to the bearing temperature, it must not exceed 50 to 65 ° C. We should always pay attention to the motor, voltage, current, temperature, sound.Also, we should often pay attention to the lubrication system, the oil tank may not exceed 35 to 40 ° C, the pressure of the tubing should be maintained at 1.5 to 2.0 kg / cm . Check the lubrication condition of the transmission components of the gear, main bearing, and observe whether the ball mill around the end cap, discharge box, grading machine are blocked or drained the sand. Always pay attention to the changing nature of the ore, and take appropriate measures according to the situation in a timely manner. When stopping the ball mill, you should first stop the feeding machine, and then stop the motor of ball mill, and finally stop the oil pump of ball mill . With the grader lifting device, pull the spiral out of the sand surface, then stop classifier.autora. >